Job Description

Mechanical Engineer – Electronics Packaging

12-18 Month Contract  M-F 40 hours weekly

 

 As a Mechanical Engineer- Electronics Packaging specialist, you will be responsible for developing portions of the lithography system and/or associated tooling related to the electronics infrastructure.

The position requires highly motivated, extremely organized and self-driven individuals.

As a Mechanical Engineer- Electronics Packaging Specialist you will:

  • Perform mechanical design and development associated with packaging electronic circuits including, assembly design, analysis, test, and manufacturing introduction support for both new and existing electronics design projects
  • Understand and mitigate possible failure mechanisms associated with materials, interconnects, and environmental loads to develop a reliable design
  • Communicate with a team of multi-disciplined engineers (Systems , Electrical, Mechanical, Manufacturing, New Product Logistics, and Product Information Management) for design and logistic release approval
  • Investigate and edit product structures, generate CAD models, 2D/3D drawings and be responsible for the final technical data package
  • Create, edit, review, and drive Engineering Changes to closure
    • Self-Checking and Peer-Checking department designs and change notifications

Experience and Education: 

  • 5 to 10 years of Mechanical design & logistics
  • BS Engineering with a major in any of the following:
    • Mechanical Engineering (with Electronics Packaging Experience preferred)
    • Industrial Engineering (taken under advisement based on work experience)

Qualifications: 

  • Ability to design and document all aspects of the electrical infrastructure including:
    • AC, DC, Main power distribution (panel boards, boxes and cabinets)
    • Interconnect cables, bundles and connectors (harnessing)
    • Electronic racks, cabinets, control consoles
    • Interfacing with printed circuit board designs
      • Modeling of flex and rigid PWB’s including volumes and critical part locations
  • Experience designing electronic enclosure assemblies
  • Experience in sheet metal design         
  • Experience designing for manufacturability (DFM) and developing assembly work instructions for low to medium volume products
  • Experience with 3D solid modeling for design conceptualization and realization (preferred experience using NX)
  • Experience supporting design fit check during integration & testing of electrical & electronic systems at the module, sub-system & system level
  • Knowledgeable of industry codes and standards ( i.e. NEC 70, NFPA 79, Machine Tool Standards)
  • Knowledge of FEA is a plus
  • Working knowledge of wiring diagrams and schematic diagrams
  • Working knowledge of design drafting best practices including geometric dimensioning
    • Perform dimensional and tolerance analysis as needed
  • Strong written and verbal communication skills required
    • Ability to write assembly, test procedures, test specifications and test reports

 

SOFTWARE:

  • 3D CAD-  NX preferred (currently using NX11), other 3D CAD programs acceptable
  • DMS -TeamCenter preferred (currently using TC10), other DMS programs acceptable
  • Master Data-SAP, other Master Data Management systems acceptable

Application Instructions

Please click on the link below to apply for this position. A new window will open and direct you to apply at our corporate careers page. We look forward to hearing from you!

Apply Online